If you have been reading about DMSO stock and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-10-15. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
For long-term storage, SR9009 is typically kept as a solid at low temperature, protected from moisture and light. Desiccated conditions limit hydrolysis, while opaque containers reduce photochemical breakdown. Solutions are less stable than solids and are often stored frozen in aliquots to avoid repeated freeze-thaw cycles. Stability data are not standardized across all suppliers, so users should rely on certificate-of-analysis information when available. Degradation may appear as color change, precipitate, or decreased chromatographic purity.
In laboratory settings, SR9009 is commonly identified by its molecular structure and its interaction with REV-ERB receptors. Vendors may list it under synonyms such as Stenabolic or REV-ERB agonist, but those names do not define purity or identity. Analytical confirmation typically uses high-performance liquid chromatography with ultraviolet detection or liquid chromatography–mass spectrometry. A reference standard is needed to compare retention time and mass spectrum, because the compound can be confused with related research chemicals.
Handling practices for SR9009 focus on minimizing degradation and contamination. The solid is generally stored desiccated at or below -20 °C, protected from light and moisture. Stock solutions are often prepared in dimethyl sulfoxide or ethanol, then aliquoted to avoid repeated freeze–thaw cycles. Aqueous solubility is low, so formulations for animal studies may require cosolvents or suspending agents. Personnel should follow institutional chemical safety procedures, because toxicological data for humans are incomplete.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
SR9009 is a synthetic small molecule studied as an agonist of the nuclear receptors REV-ERBα and REV-ERBβ. These receptors help regulate circadian rhythms and metabolic gene expression. In laboratory experiments, SR9009 binds these receptors and alters transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. It is not a naturally occurring compound and has no approved therapeutic use. Research interest stems from its ability to modify energy metabolism in cells and animal models.
In rodent studies, SR9009 has been reported to increase mitochondrial content in skeletal muscle and improve exercise endurance under some conditions. These findings led to popular descriptions such as an exercise mimetic, although that term oversimplifies the biology. Effects vary by dose, timing, tissue, and model. The compound's influence on circadian pathways means that time of administration can matter in experiments. Whether similar metabolic changes occur in humans remains largely unexplored in controlled published trials.
ATAC-seq (Assay for Transposase-Accessible Chromatin using sequencing) is a laboratory technique used in molecular biology to assess genome-wide chromatin accessibility. The technique was introduced in 2013 by the labs of Will Greenleaf and Howard Chang at Stanford University as an alternative to MNase-seq, FAIRE-Seq and DNase-Seq with faster turnaround time, simpler protocol, and lower DNA input requirements.
No paralogs of c7orf26 have been found in the human genome, however, six unique isoforms have been identified. They are c7orf26 isoform (X1, X2, X3, X4) and isoform 2 (two sub-isoforms identified). Below is a table of a variety of orthologs of the human c7orf26. The table include closely, intermediately and distantly related orthologs. Orthologs of the human protein c7orf26 are listed above in descending order of the date of divergence. c7orf26 is highly conserved throughout all orthologs, this is demonstrated with a 65% identity in the least similar ortholog. c7orf26 has evolved slowly and evenly over time. Below is a phylogenetic tree showing the evolutionary history of c7orf26 and its nearest orthologs.
People with Aarskog–Scott syndrome often have distinctive facial features, such as widely spaced eyes (hypertelorism), a small nose, a long area between the nose and mouth (philtrum), and a widow's peak hairline. They frequently have mild to moderate short stature during childhood, but their growth usually catches up with that of their peers during puberty. Hand abnormalities are common in this syndrome and include short fingers (brachydactyly), curved pinky fingers (fifth finger clinodactyly), webbing of the skin between some fingers (cutaneous syndactyly), and a single crease across the palm. Other abnormalities in people with Aarskog–Scott syndrome include heart defects and a split in the upper lip (cleft lip) with or without an opening in the roof of the mouth (cleft palate). Most males with Aarskog–Scott syndrome have a shawl scrotum, in which the scrotum surrounds the penis instead of hanging below. Less often, they have undescended testes (cryptorchidism) or a soft out-pouching around the belly-button (umbilical hernia) or in the lower abdomen (inguinal hernia). The intellectual development of people with Aarskog–Scott syndrome varies widely. Some may have mild learning and behavior problems, while others have normal intelligence. In rare cases, severe intellectual disability has been reported.
Sources: en.wikipedia.org
Formation of the Quinonoid Intermediate PLP acts as an 'electron sink' absorbing delocalized electron density during the reaction intermediates (countering the excess electron density on the deprotonated a-carbon). PLP facilitates the enzyme activity, increasing the acidity of the alpha carbon by stabilizing the conjugate base. The PLP-stabilized carbanion intermediate formed is the quinonoid intermediate. Tyrosine and PLP stabilized 3C-Ring formation PLP and Tyrosine stabilize negative charges during deprotonation. Tyrosine attacks the sulfur bound carbon, allowing S(CH3)(Ado) to leave, and during ring formation, Tyrosine leaves. Note inhibitors AVG and AMA bind PLP to form a ketimine and oxime respectively (whose reverse reactions are much less favorable) and prevent the ACC synthase catalyzed reaction with SAM.
The circadian oscillators in eukaryotes that have been studied function using a negative feedback loop in which proteins inhibit their own transcription in a cycle that takes approximately 24 hours. This is known as a transcription-translation-derived oscillator (TTO).(2) Without a nucleus, prokaryotic cells must have a different mechanism of keeping circadian time. In 1998, Ishiura et al. determined that the KaiABC protein complex was responsible for the circadian negative feedback loop in Synechococcus by mapping 19 clock mutants to the genes for these three proteins.(3) An experiment by Nakajima et al., in 2005, was able to demonstrate the circadian oscillation of the Synechococcus KaiABC complex in vitro. They did this by adding KaiA, KaiB, KaiC, and ATP into a test tube in the approximate ratio recorded in vivo. They then measured the levels of KaiC phosphorylation and found that it demonstrated circadian rhythmicity for three cycles without damping. This cycle was also temperature compensating. They also tested incubating mutant KaiC protein with KaiA, KaiB, and ATP. They found that the period of KaiC phosphorylation matched the intrinsic period of the cyanobacterium with the corresponding mutant genome. These results led them to conclude that KaiC phosphorylation is the basis for circadian rhythm generation in Synechococcus. (2)
Ash is the solid remnants of fires. Specifically, ash refers to all non-aqueous, non-gaseous residues that remain after something burns. In analytical chemistry, to analyse the mineral and metal content of chemical samples, ash is the non-gaseous, non-liquid residue after complete combustion. Ashes as the end product of incomplete combustion are mostly mineral, but usually still contain an amount of combustible organic or other oxidizable residues. The best-known type of ash is wood ash, as a product of wood combustion in campfires, fireplaces, etc. The darker the wood ashes, the higher the content of remaining charcoal from incomplete combustion. The ashes are of different types. Some ashes contain natural compounds that make soil fertile. Others have chemical compounds that can be toxic but may break down in soil from chemical changes and microorganism activity. Like soap, ash is also a disinfecting agent (alkaline). The World Health Organization recommends ash or sand as alternative for handwashing when soap is not available. Before industrialization, ash soaked in water was the primary means of obtaining potash.
Sources: en.wikipedia.org
Once the substrate is bound and oriented to the active site, catalysis can begin. The residues of the catalytic site are typically very close to the binding site, and some residues can have dual-roles in both binding and catalysis. Catalytic residues of the site interact with the substrate to lower the activation energy of a reaction and thereby make it proceed faster. They do this by a number of different mechanisms including the approximation of the reactants, nucleophilic/electrophilic catalysis and acid/base catalysis. These mechanisms will be explained below.
Arterial damage results from white blood cell invasion and inflammation within the wall. CRP is a general marker for inflammation and infection, so it can be used as a very rough proxy for heart disease risk. Since many things can cause elevated CRP, this is not a very specific prognostic indicator. Nevertheless, a level above 2.4 mg/L has been associated with a doubled risk of a coronary event compared to levels below 1 mg/L; however, the study group in this case consisted of patients who had been diagnosed with unstable angina pectoris; whether elevated CRP has any predictive value of acute coronary events in the general population of all age ranges remains unclear. Currently, C-reactive protein is not recommended as a cardiovascular disease screening test for average-risk adults without symptoms. The American Heart Association and U.S. Centers for Disease Control and Prevention have defined risk groups as follows:
Cilengitide, a cyclic pentapeptide (RGDfV), is an investigational drug intended to block the growth of new blood vessels in tumors by interfering with the activation of integrin αVβ3. This integrin is upregulated in tumor and activated endothelial cells. This and other anti-angiogenic therapies depend on cutting off the blood supply to the tumor micro-environment, leading to hypoxia and necrosis. Cilengitide has been evaluated for the treatment of glioblastoma, but, as is the case for other anti-angiogenic therapies, has not been shown to alter progression or improve survival either alone or in combination with standard treatments. CEND-1, also known as iRGD, is a cyclic peptide that homes to tumors via binding to integrin alpha V receptors. It also binds and activates neuropilin-1, leading to a temporary opening of the tumor and an enhanced delivery of anti-cancer agents into the tumor tissue. It is currently being tested in clinical trials in solid tumor patients.
Being the smallest alkali metal, lithium forms the widest variety of and most stable organometallic compounds, which are bonded covalently. Organolithium compounds are electrically non-conducting volatile solids or liquids that melt at low temperatures, and tend to form oligomers with the structure (RLi)x where R is the organic group. As the electropositive nature of lithium puts most of the charge density of the bond on the carbon atom, effectively creating a carbanion, organolithium compounds are extremely powerful bases and nucleophiles. For use as bases, butyllithiums are often used and are commercially available. An example of an organolithium compound is methyllithium ((CH3Li)x), which exists in tetrameric (x = 4, tetrahedral) and hexameric (x = 6, octahedral) forms. Organolithium compounds, especially n-butyllithium, are useful reagents in organic synthesis, as might be expected given lithium's diagonal relationship with magnesium, which plays an important role in the Grignard reaction. For example, alkyllithiums and aryllithiums may be used to synthesise aldehydes and ketones by reaction with metal carbonyls. The reaction with nickel tetracarbonyl, for example, proceeds through an unstable acyl nickel carbonyl complex which then undergoes electrophilic substitution to give the desired aldehyde (using H+ as the electrophile) or ketone (using an alkyl halide) product.
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
Liquid chromatography–mass spectrometry is common for identity and purity checks. High-performance liquid chromatography with ultraviolet detection can also be used. Both methods require a suitable reference standard.